The higher force range of instrumented indentation testing (IIT)
The Microindentation Tester is ideally suited to the measurement of mechanical properties such as hardness and elastic modulus based on instrumented indentation testing (IIT). It is applicable to bulk samples and thin films, from soft to hard materials (metals, ceramics, polymers) with a high depth of measurements (up to 1 mm). A scratch testing module can be added optionally.
Instrumented indentation testing (IIT) for hardness and elastic modulus
• Depth-instrumented indentation: the penetration depth is continuously monitored as a function of the force applied in order to measure not only the hardness of materials but also the elastic modulus
From nano- to macro indentation in one single instrument
• Microindents from low depths (a few nm for surface detection) to high depths (maximum 1 mm)
• Large range of force applied (from 10 mN to 30 N) in order to match the sample characteristics
• High force range specifically useful for rough surfaces
High precision on depth and force for accurate microindentation measurements
• Two independent sensors: one for force and one for depth for accurate metrological measurements
• High frame stiffness: 2 x 108 N/m for increased depth accuracy
Depth-profiling of material properties
• Depth profiling with Continuous Multi Cycles (CMC): hardness and elastic modulus as a function of penetration depth
• Force- and depth-controlled modes
• Visual matrix with multi-selection of indent positions on a specific surface area
• Multiple modes of testing: user-defined sequences to be able to set the parameters for testing conditions as desired
| Model | MHT³
|
| Force |
| Max. force | 30 N |
| Resolution | 6 μN |
| Depth |
| Max. depth | 1000 μm |
| Resolution | 0.03 nm |
| |
| Load frame stiffness | > 107 N/m |
| International standards | ISO 14577, ASTM E2546, ISO 6507, ASTM E384 |
| |
To get information about: «MHT³» contact us by phone (044) 229 15 31 or fill in the form.