The single sample changer for a wide range of samples

The new industrial grade peristaltic pump in combination with automatic cleaning makes Xsample 330 perfectly suitable for measuring single low-viscosity samples with widely different properties in direct succession. Once measured, the sample is drained or recovered and the system is automatically cleaned with up to two cleaning agents. A drying step is performed by the operator to perfectly prepare the measurement cell(s) for the next sample.

Automatic cleaning
• Automatic rinsing and drying after each sample for perfect preparation of the system
• Up to two different cleaning agents can be used in any order for an individual cleaning procedure.
• Advanced settings for cleaning procedures to increase measuring performance

For a wide range of samples
• Filling with peristaltic pump covers a wide range of different sample viscosities up to 3,000 m.Pas
• All wetted parts of Xsample 330 (high resistance) are made of durable materials for aggressive samples, such as phosphoric acid or trichloroacetic acid
• Adjustable filling modes for different types of samples enable perfect measuring results

Highly efficient sample handling and easy operation
• Depending on the system size, only a minimum amount of sample volume is needed to perform a measurement
• Easy operation by an integrated user interface on the master instrument
• Straightforward measurements of different sample viscosities due to a sensor-controlled stop of the filling procedure
• Automatic sample recovery returns expensive or hazardous samples back to their vials

Model	Xsample™ 330 (High-resistance)
Viscosity range	up to 3,000 mPa•s at ambient and measuring temperature№
Filling mode	with peristaltic pump:
	Suction mode in one direction
	Suction mode with pumping back and forth at the beginning
Typical time for filling	2 to 5 minutes
and measuring cycle
Minimum sample volume	approx. 10 mL to 20 mL
Compressed air supply	max. 2 bar (29 psi) relative
	Class 3 according to ISO 8573-1:
Quality of air necessary	max. particle size: 5 μm
	max. pressure dew point: –20 °C
	max. oil content: 1 mg/mі
Environmental conditions	indoor use only
(EN 61010)
Operating temperature	+15 to +35 °C
Pollution degree	2
Over voltage category	II
Altitude	max. 3,000 m (9,840 ft)
Power supply	supplied by the master instrument
	AC power supply voltage according to technical data plate
	at the rear of the master instrument
	(protective grounding required)
Dimensions LxWxH         Xsample™	205 mm x 148 mm x 185 mm
330Xsample™ 330 High-resistance	205 mm x 148 mm x 205 mm
Weight excl. master instrument
Xsample™ 330	approx. 3.7 kg
Xsample™ 330 High-resistance	approx. 3.8 kg
№ Recommended for samples with a viscosity up to 500 mPa•s at ambient and measuring
temperature. For samples with a viscosity higher than 500 mPa•s at ambient and
measuring temperature, bubbles may occur during filling

⚬ Cleaning Recommendations for Alex 500

⚬ Petroleum Industry Anton Paar process solution throughout all production steps

⚬ Базові відомості про масу та густину

⚬ Визначення в'язкості розчинів метилцелюлози

⚬ Визначення концентрації шляхом вимірювання густини

⚬ Використання принципу осцилюючої U-трубки в лабораторних електронних густиномірах

⚬ Густина рідин

⚬ Приклади використання вимірювання густини